News Center
What does the connecting rod assembly consist?
2023-05-06
The connecting rod is an integral part of the piston connecting rod mechanism, which includes the shaft, the bearing cover (pot cover) bolts, the bearing (small pot) and the piston pin sleeve (brass sleeve). The connecting rod is a key component directly related to the durability or reliability of the engine. During the warranty period, attention should be paid to whether the following parts of the connecting rod are normal.
What is the role of car connecting rods
2023-05-06
The connecting rod is a rod-shaped zero zhidao piece that connects the piston and the crankshaft. Its function is to transmit the huge pressure of the piston to the crankshaft, so that the crankshaft makes a circular motion. The connecting rod is composed of three parts: the small end of the connecting rod, the rod body and the big end of the connecting rod.
The role of car steering connecting rod
2023-05-06
The steering connecting rod is a rod-shaped member that connects the piston and the crankshaft. Its function is to transmit the pressure of the piston to the crankshaft, so that the crankshaft makes a circular motion. The connecting rod is composed of three parts: the small end of the connecting rod, the rod body and the big end of the connecting rod. The small end of the connecting rod is integrated with the connecting rod, and the hole is equipped with a bronze bushing, which is connected to the piston with a piston pin; the cross section of the shaft is I-shaped, which can reduce the mass under the same strength and rigidity, and make it not under pressure Deformation; the big end of the connecting rod is divided into two parts, the upper part is cast into the shaft, and the lower part is the connecting rod bearing cover, which is connected with the upper part with the bolt. In order to make the big end of the connecting rod smoothly extracted from the cylinder, the big end of the connecting rod has two forms: flat cut and oblique cut. The big end of the connecting rod is equipped with two semicircular connecting rod bearings. In order to reduce the friction of the connecting rod journal, a layer of anti-wear alloy is poured on the bearing surface. The positioning between the connecting rod and the bearing cover is generally in the form of a stopper, which is matched with the positioning sleeve according to the tooth shape to make the two accurately fit.
Technical requirements for automotive steering rods
2023-05-06
The product shall meet the requirements of this standard and shall be manufactured in accordance with the drawings and documents approved by the prescribed procedures.
Composition and function of automobile chassis
2023-05-06
The role of the chassis is to support and install the car engine and its parts and assemblies to form the overall shape of the car, and receive the power of the engine to make the car move and ensure that the car can run normally.
Structural Characteristics of Automobile Transmission Shaft
2023-05-06
The drive shaft is an indispensable part of a car, just like a person cannot live without an arm. The drive shaft is composed of a shaft tube, a telescopic sleeve and a universal joint. The telescopic sleeve can automatically adjust the distance between the transmission and the drive axle.
Contact Us
Add:Mei'ao Village Industrial Zone, Longxi Town, Yuhuan County, Zhejiang Province
Fax: 0576-87497120
Wap
Copyright©2023 Yuhuan Sanhe Machine Tool Factory (General Partnership) All Rights Reserved